Product code: 1019035

The cordless compressor allows you to monitor tire pressure so that you don't over-inflate. It takes about 3.5 minutes to fully inflate a wheel. The product is equipped with a universal USB Type C port, which increases its charging speed. The pumping tip is made of metal so it's extremely durable and the locking clasp makes it so you don't have to hold the tip while pumping.Thanks to the built-in LCD display on the battery level and pressure will be known at all times.

In the set you will also find 3 types of nozzles:
- American - car and bicycle tires
- French - sports motorcycles, mountain bikes
- ball needle

Compatibility
The pump fits cars, other vehicles and sports accessories.

Monitoring
The device is equipped with a tire pressure level monitoring system. You can adjust at will - reduce or increase the amount of air in the tires to make daily driving easier and more enjoyable. The smart chip stops charging after the tire pressure reaches the maximum level.

High-quality construction
The manufacturer used metal to create a sturdy case with an elegant texture. It not only looks striking, but also has very good durability characteristics. In addition, he implemented solutions for heat dissipation - the device does not overheat. This is due to the 274 holes on each side of the case. The cables are covered with natural rubber, which is bendable and will not break.

Simple operation
Operation of this pump is very simple and intuitive. The buttons used here are easy to feel under the fingers. By monitoring the tire pressure level, the risk of overcharging is reduced to a minimum. At your disposal you have the following buttons:

• - M - a short press turns the device on, holding for 3 seconds switches between modes,
• - +/- - a short press is enough to increase or decrease the amount of pumped air,
• - OK - press and hold for 3 seconds to turn off,
• - Light - press to turn on the light, press again to turn on the strobe light, another press will turn on the SOS light signal.

• - Connect and install the various parts of the pump.
• - Press the M button to prepare the device for operation.
• - Connect the pump to the valve and press OK to start operation.
• - Finish when the charge is full.

• - Brand: Baseus
• - Weight: 1320g
• - Input voltage: 5V / 3A; 9V / 1.5A
• - Battery capacity: 6000mAh (22.2Wh)
• - Power: 250W
• - Charging time: about 4-5 hours
• - Size: 230 x 99 x 64mm
• - Compatible with vehicle models: SUV, passenger, business, motorcycles, kayaks, ball bikes, inflatable mattresses

• - pump,
• - charging cable,
• - tube with pumping tip,
• - 2 x nozzle (American, French)
• - ball needle